Sinotimer Mc101 Manual -

To enter the parameter menu, hold the button for 3-5 seconds. Use SET to switch between parameters and arrows to change values. Description SL1cap S cap L 1 Input Sensor Defines sensor type (0:K, 1:E, 3:Pt100) Units C: Celsius / F: Fahrenheit Proportional PID Parameter (Lower = faster response) Integral PID Parameter (Eliminates steady-state error) Derivative PID Parameter (Reduces overshoot) ATcap A cap T Auto-Tune Set to 1 to run AT, 0 to stop AH1cap A cap H 1 Alarm High Alarm activates above this value AL1cap A cap L 1 Alarm Low Alarm activates below this value 5. Auto-Tuning (AT) - How to Optimize Performance

Increases the target temperature or parameter value. 4. How to Program the Target Temperature (SV) Changing your target temperature takes only a few seconds: sinotimer mc101 manual

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. To enter the parameter menu, hold the button for 3-5 seconds

Proper wiring is critical to prevent damage to the unit. The terminal mapping is typically located on the side of the housing. Description Power Input AC 100-240V (Live/Neutral) 3-4-5 Alarm Output ALM1 Relay Contact 6-7-8 Control Output SSR Voltage Output (6+, 7-) 9-10-11 Sensor Input Thermocouple (+/-) or Pt100 (3-wire) Wiring Instructions: Power: Connect AC Power to Terminals 1 and 2. Auto-Tuning (AT) - How to Optimize Performance Increases

| Problem | Possible Cause | Solution | | :--- | :--- | :--- | | | No power to the unit; Incorrect wiring; Blown fuse. | Check power at Terminals 1 & 2; Verify wiring; Inspect fuse. | | Incorrect Temperature Reading | Sensor wiring error; Wrong sensor type selected in settings; Damaged sensor. | Verify sensor wiring to Terminals 8, 9, 10; Check controller's input type setting; Replace sensor if needed. | | Temperature Unstable / Overshoots | PID parameters are not optimized for the system. | Run the Auto-Tune function to let the MC101 optimize its parameters. | | Output Not Activating | Output wiring error; Output type mismatch (relay/SSR); Controller is in manual mode. | Check relay/SSR wiring; Ensure output type matches connected device; Switch controller to automatic control mode. |

Set it to or "ON" to begin the tuning process. The controller will cycle the heat to determine optimal settings. Changing Input Type : Access the internal menu by holding SET .