Hanmatek Dos1102 Manual [BEST]

Connect the black alligator ground clip to the ground terminal loop directly next to it. Press the button on the front panel. Step 4: Adjusting the Probe Look at the square wave on the screen.

Look at the square wave on the screen. If the corners are rounded (under-compensated) or have spikes/overshoot (over-compensated), use the small plastic screwdriver included with your probes to adjust the adjustment slot inside the BNC end of the probe. Rotate it until the tops and bottoms of the square wave are perfectly flat. 4. Navigating the Menu System and Features hanmatek dos1102 manual

Navigates on-screen menus for settings, storage, and utility. 4. Operating the (Step-by-Step) 4.1 Measuring Voltage and Frequency (Automatic) Connect your signal to CH1 . Press AUTOSET for a quick view. Press the MEASURE button. Connect the black alligator ground clip to the

Check the attenuation switch on your probe (1X or 10X). For most digital work, 10X is preferred as it increases the input impedance and protects the scope from higher voltages. Periodically check the Hanmatek Official Support Look at the square wave on the screen

For beginners, the button is the fastest way to get a readable signal. When pressed, the internal microprocessor samples the incoming signal voltage and frequency, then dynamically adjusts the vertical, horizontal, and trigger parameters for an optimal display. Automated Measurements