Even if your light only uses 8 or 14 channels, you must start it on these addresses (17, 33, 49, etc.). If you set a light to "Address 2," the Disco 240 will not control it properly because it is expecting channel 2 to be part of Fixture 1's 16-channel block.
Used to store and recall specific "looks" or programmed steps. Speed & Fade Sliders: disco 240 dmx controller manual
While the Disco 240 is an entry-level desk, it does offer some advanced features: Even if your light only uses 8 or
Tap the where you want to save the look. The LED display will flash, confirming the scene is saved. Speed & Fade Sliders: While the Disco 240
To help customize this guide for your specific setup, could you share a few details? Let me know:
A: Yes – but you need two consecutive faders. For example, if your light uses channel 1 (coarse pan) and channel 2 (fine pan), assign the light to start at DMX address 001. Then fader 1 = coarse, fader 2 = fine.