Ld-c101 Usb To Ci-v Driver |top|

The LD-C101 is not just a simple cable; its internal circuit board has been documented by hobbyists. The PCB contains unpopulated pads for an optocoupler connected to the DTR signal line. This allows advanced users to modify the cable by soldering in an optocoupler IC. This modification enables hardware-based Push-To-Talk (PTT) control directly from the computer's RTS or DTR line, which is a useful feature for digital modes on older ICOM radios that lack a CI-V PTT command. Additionally, the cable's design even includes the designer's amateur radio callsign (BD7JAO) on the board.

Follow these steps to install the LD-C101 driver on Windows operating systems. 1. Download the Correct Driver Ld-c101 Usb To Ci-v Driver

Icom uses the Communication Interface V (CI-V) protocol for transceiver control, operating on a bi-directional, single-wire TTL serial network. The LD-C101 is not just a simple cable;

: Open your radio's internal menu and check the CI-V Baud Rate (common speeds are 9600, 19200, or Auto). In your software settings, set the baud rate to match your radio exactly. In your software settings